Xblitz RF500 CAM Handbuch Seite 17

07. FAQ
1. No power
- the car's engine is turned off,
- if the power supply for accessories is installed in the car, you can turn the
car key to ACCto provide power to the accessories,
- if the power circuit is burnt, change it,
- if the temperature in the car is too high, lower it and try again
2. No sound
- if the sound it set to minimum, set it to a proper value,
- improper wiring, improper file format or damaged files on the drive can cause
the lack of sound
3. No radio reception
- if the antenna is not connected properly or the reception is weak, make sure
that the antenna is properly mounted in place,
- if you cannot find any radio stations during an automatic scan, the
broadcasting signal can be too weak for the device to pick it up. Try tuning it
manually.
4. Wiring diagram
- make sure that the casing is properly grounded Proper grounding eliminates
most issues with electronic noise. Good grounding of the casing require
connecting it to the car's chassis. The area around the connection should be
thoroughly cleaned - with no rust, paint, plastic or dust
quality
08. SPECIFICATION
Voltage; 12Vcarbattery (groundedcathode)
BT version:
Built-in memory:
Front panel.
Modifiable tone settings: bass/treble/ balance/equalizer
FM frequency range
Maximum FM sensitivity:
FM Signal To Noise Ratio:
Supported audio formats:
Supported video formats:
Supported Image Formats:
Operating range: -10 to 55 degrees
FM separation at 1kHz.
Display:
5" LCD
Power. • 4x50W
RCA•
18 stations
Service: USB up to 326B
• stable
: 87 5MHz-108MHz
É37dBf
240dB
MP3/FLAC/AAC/APE
MP4/AV/DlVX/WMA/RMVB/MKV/PMP/FLV/M2TS/MPG
JPEG/GIF/PNG
• 222dB
for best grounding
EN