Herunterladen Inhalt Inhalt Diese Seite drucken

JUNO JCF84181 Benutzerinformation Seite 9

Kühl-gefrierschrank
Vorschau ausblenden Andere Handbücher für JCF84181:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Problem
The compressor operates
continually
Water flows at the back
plate of the refrigerator
Water flows into the re-
frigerator compartment
Water flows onto the floor The melting water outlet flows not
The lamp does not work.
It is too warm in the re-
frigerator
It is too cold in the refrig-
erator
There is too much frost
and ice
It is too warm in the freez-
er
Possible cause
The Temperature Regulator may
be set incorrectly
The door does not close tightly or
it is not shut properly
The door has been opened too
frequently
Food placed in the appliance was
too warm
The temperature of the room that
contains the appliance is too high
for efficient operation
During automatic defrosting, frost
melts on the back plate
The outlet can be clogged up
Products placed in can prevent
water from flowing into the col-
lector
into the evaporative tray above
the compressor
The lamp is in stand-by.
The lamp is defective.
The Temperature Regulator may
be set incorrectly
The door does not close tightly or
it is not shut properly
Food placed in the appliance was
too warm
Large quantities of food to be
cooled were put in at the same
time
There is no inside cool air circu-
lation
The Temperature Regulator may
be set incorrectly
Products are not wrapped prop-
erly
Doors are not shut properly or do
not close tightly
The Temperature Regulator may
be set incorrectly
Temperature Regulator may be
set incorrectly
Solution
Set a warmer temperature
Check if the doors close well and
the gaskets are undamaged and
clean
Do not leave the door open longer
than necessary
Allow food to cool to room tem-
perature before storing
Try to reduce the temperature in
the room where the appliance
stands
It is normal
Clean the outlet
Replace the products so that they
can not touch the back plate di-
rectly
Put the melting water outlet to the
evaporative tray
Close and open the door.
Refer to "Replacing the lamp".
Set a lower temperature
Check if the door closes well and
the gasket is undamaged and
clean
Allow food to cool to room tem-
perature before storing
Insert smaller quantities of food to
be cooled at any one time
Provide inside cool air circulation
Set a higher temperature
Wrap the products better
Check if the doors close well and
the gaskets are undamaged and
clean
Set a warmer temperature
Set a lower temperature
electrolux 9

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis