Usage - Vulpes Goods Tech Pro Anleitung

USAGE

To use the pump correctly, it should be fully charged
before first use. Charge the compressor with the
supplied charging cable.
Activate the pump by pressing and holding the on/off
button for 3 seconds.
Finally,add the right connection for the right purpose.
Insert the connection into the valve, press the on/off
button and the compressor starts pumping. The figures
on the screen indicate the current pressure.The figures
increase as soon as the compressor pumps. The
compressor
is reached
It is possible to stop pumping earlier. In this case, press
the on/off button again. The pump will stop pumping.
Complete switch-off can be done by pressing the on/
off button again for 3 seconds.
Note: Before pumping, always check the required
pressure of the product
COPYRIGHT@ALL RIGHTS RESERVED gyvuLPES GOODs•
Then select the desired
turns itself off once the desired pressure
to be pumped.
mode.
9