Vulpes Goods TECH PRO Anleitung Seite 7

Mode selection
Activate the pump by pressing and holding the on/off
button for 3 seconds. After turning on the
compressor, there is a choice Of 5 modes. Switching
between modes can be done by pressing the mode
selection button.
Zero mode
There is no icon visible on the display, press and hold
the mode selection button to change pressure unit.
Press the + or - button to set the desired pressure.
This mode is useful for units above
pre-programmed settings
Auto mode
The auto icon is visible on the display. Pressing the + or
- button changes the pressure. Changing the pressure
unit is possible by pressing and holding the mode
selection button
Scooter/motorbike
The scooter/motorbike
Pressingthe + or - button changes the pressure.
Changing the pressure unit is possible by pressing and
holding the mode selection button
Bicycle mode
The bicycle icon is visible on the display. Pressing the
+ or - button changes the pressure. Changing the
pressure unit is possible by pressing and holding the
mode selection
COPYRIGHT@ALL RIGHTS RESERVED gyvuLPES GOODs•
mode
icon is visible on the display.
button.
the
7