Specifications - PeakTech 4055 Handbuch

Parameter calibration table
Sequence Default calibration
No.
00
01
02
03
04～13
4.6.3 Disable calibration
* After finishing the calibration, press【Cal】key and there display 1900, press any numeric keys
then【N】key to store the calibration parameters, disable calibration and exit the process.
* During the calibration process, if wrong calibration occurred, press 【Freq】key at any time to disable
calibration and exit without storing calibration parameters.
* After rebooting, the generator automatically recalls and uses the calibration parameters stored during last
calibration.

5. Specifications

5.1. Output characteristics of channel A
5.1.1. Waveform characteristics
Waveform types:
Waveform length:
Sampling rate:
Amplitude resolution:
Harmonic distortion:
Total distortion:
Pulse, square:
Duty cycle:
Ramp symmetry:
5.1.2. Frequency characteristics
Frequency range:
Resolution:
Frequency accuracy:
5.1.3. Amplitude characteristics
Amplitude range:
Resolution:
Amplitude accuracy:
Amplitude flatness:
Output impedance:
Output nominal
value
485
950
885
500
100
16 types including sine, square, ramp, exponent, noise and so on ..
1024 points
100 MSa/s
8 bits
≤40dBc (<1MHz / 1 Vpp)
≤35dBc (≥1MHz)
≤1% (20Hz ~ 200kHz / 20 Vpp)
rise/fall time: ≤50ns, over shoot: ≤ 10 %
1% ~ 99%
0 ~ 100 %
sine: 40mHz ~ 3 MHz
others: 40mHz ~ 1 MHz
40mHz
-5
±(2×10 + 40mHz)
0mVpp ~ 20Vpp (open circuit load)
0mVpp ~ 10Vpp (50 Ω load)
20mVpp (for amplitude>2V), 2mVpp(for amplitude <2V)
±(1% + 2mV)(frequency is 1kHz / > 5 mVrms)
±10% (sine, compared to 1 MHz, 10 Vpp)
50Ω
Adjust the calibration value till the output
value
Zero calibration: output DC voltage as
0Vdc
Offset calibration: output DC voltage as
10Vdc
Amplitude calibration: output AC voltage as
3.5Vrms
Frequency calibration: output frequency as
1MHz
Flatness calibration: output amplitude as
10Vpp
-27-
is within the error range
－30～30mVdc
9.87～10.13Vdc
3.464～3.536Vrms
1MHz±20Hz
9.0Vpp～11.0Vpp