Homend FANOMEN Gebrauchsanweisung Seite 15

BASE AND PILLAR ASSEMBLY:
1. Take out base and pillar parts from the carton
2. Revolve the height adjustor anti-clock wisely out. draw the steel
tube out of the pillar Then remove the height adjustor clock-wisely to
fasten it.
3. Locate the pillar proper into the base, take the screw nut from the
plastic bag and fit it to the pillar from the bottom of the base and
fasten it
4. Adjust the height adjustor to meet you requirement of the height
of the fan
FAN BODY ASSEMBLY:
Unscrew the fixing knob on the bottom of fan body, empty the hole in
the bottom of fan body.
Put extension column into the hole of the fan body, then tighten the
Fun blade
fixing knob.
Fun hub
Rear guard
Front guard
Fun cover
Motor shaft
Plastic salmon
I. Remove the spinner and the plastic nut from the front side of the
motor shaft then tighten the plastic nut lake the plastic rim out of
packing carton, slip the ring of the rear grill into the deep slot of (he
plastic rim. screw the bolt in the joint of the rim properly.
2. Insert the blade into shaft, make sure the stopper pm is clipped
F A N O M E N U S E R ' S M A N U A L 1 3