Fulbat MF Bedienungsanleitung Seite 7

5 PULLING OUT THE CONTAINER
S PULLING OUTTHE
Be certain that all the electrolyte has flowed out. Tap the bottom in the same way as step 4
Be certain that all the electrolyte has flowed out. Tap the bottom in the same way as step 4
if there is any electrolyte left in the container.
if there is any electrolyte left in the container.
Now pull the container gently out of the battery.
Now pull the container gently out of the battery.
6 SEALING THE BATTERY
O SEALING THE BATTERY
Fit the strip cap plug tightly into the filler ports.
Fit the strip cap plug tightly into the filler ports.
Make sure the strip is at the same level as
Make sure the strip is at the samelevel as
the top of the battery.
the top of the battery.
The fill-up is now complete.
The fill-up is now complete.
Never remove the caps, no add any
Never remove the caps, no add any
water or electrolyte.
water or electrolyte.
IMPORTANT INFORMATIONS
IMPORTANT
(1) This battery is a fully charged and sealed before first use, integrating a venting valve.
(l) This battery is a fully charged and sealed before first use, integrating a venting valve.
It contains non-floating electrolyte and any gas produced during use is fully absorbed within
It contains non-floating electrolyte and any gas produced during use is fully absorbed within
the battery, ensuring that this battery is totally Maintenance Free.
the battery, ensuring that this battery is totally Maintenance Free.
(2) As this battery was activated before installation, it is essential that the battery stands
(2) As this battery was activated before installation,it is essentialthat the battery stands
upright during minimum 60 minutes before installation on the vehicle.
upright during minimum 60 minutes before installation on the vehicle.
This allows the electrolyte to permeate into internal materials.
This allows the electrolyte to permeate into internal materials.
(3) Under no circumstances should the Sealing Plug be removed.
(3) Under no circumstances should the Sealing Plug be removed.
(4) The Venting Valve Opening must not be obstructed.
(4) The Venting Valve Opening must not be obstructed.
CONTAINER
INFORMATIONS
FULBAT
Strip Cap Plug
Strip Cap Plug
(Battery plugs)
(Battery plugs)
Press down
Press down
horizontally on the
horizontally on the
Caps with both
Caps with both
hands
hands
7
7