Seite 1
Product Manual Piro Dining Table Designed by Michael H. Nielsen Version 001 - April/2025 Værkmestergade 11,1 8000 Aarhus C, Denmark +45 51 50 51 22...
Seite 2
Technical information As we are constantly developing and improving our products, design and technical changes may occur. This products manual can be downloaded as a PDF fi le from our website: Bolia.com Disposal of packaging & product Dispose of the product and packaging in accordance with local waste regulations.
Seite 3
Warnings GB: Do not lift at the edge – or it may break. Support from below when lifting DK: Løft ikke i kanten – det kan knække den. Understøt nedefra, når der løftes. DE: Nicht am Rand anheben – das Produkt könnte brechen. Beim Anheben von unten abstützen.
Seite 4
Warnings GB: Important safety information: This product is heavy. To avoid injury, it is recommended that lifting and handling of the product be performed by two persons. DK: Vigtig sikkerhedsinformation: Dette produkt er tungt. For at undgå skader, anbefales det, at løft og håndtering af produktet udføres af to personer. NO: Viktig sikkerhetsinformasjon: Dette produktet er tungt.
Seite 5
Warnings GB: DANGER OF TIPPING OVER – do not use furniture as a climbing assist DK: FARE FOR AT VÆLTE – brug ikke møbler som klatrehjælp DE: KIPPGEFAHR – Möbel nicht als Aufstiegshilfe verwenden NO: VELTEFARE – ikke bruk møblene som klatrehjelp SE: TIPPRISK –...
Seite 6
Use of product GB: Warning. Moisture that penetrates the wood surface can leave marks. Therefore, be careful not to leave even small splashes of liquid on the table top. DK: Advarsel. Fugt som trænger ned i træoverfladen kan efterlade mærker. Vær derfor opmærksom på...
Seite 7
Use of product GB: Do not place the furniture in direct sunlight. DK: Placer ikke møblet i direkte sollys. DE: Setzen Sie die Möbel nicht direktem Sonnenlicht aus. NO: Ikke plasser møbelet i direkte sollys. SE: Placera inte möbeln i direkt solljus. NL: Plaats het meubelstuk niet in direct zonlicht.
Seite 9
Tools, fittings and products parts ∅ Tools overview 1 25 cm A x 1 Fittings and product parts B x 24 Dia 6 X 25 mm C x 3 D x 1 E x 1...
Seite 10
Tools, fittings and products parts ∅ Tools overview 1 60 cm A x 1 Fittings and product parts B x 30 Dia 6 X 25 mm C x 3 D x 1 E x 1...
Seite 11
Assembly steps ∅ ∅ 1 25 cm + 1 60 cm STEP 01 Tools & Special requirements A x 1 B x 6 Dia 6 X 25 mm...
Seite 12
Assembly steps ∅ ∅ 1 25 cm + 1 60 cm STEP 02 Tools & Special requirements...
Seite 13
Assembly steps ∅ ∅ 1 25 cm + 1 60 cm STEP 04 Tools & Special requirements ∅ A x 1 ∅ Dia 6 X 25 mm...