Seite 1
Product Manual C3 Dining Chair Designed by Glismand & Rüdiger Version 002b - July / 2023 Vaerkmestergade 11-13 8000 Aarhus C, Denmark 51 50 51 22...
Seite 2
Always use recommended care and cleaning products. Never cover wet products. If a wet product is covered, it can be damaged. Further information can be found on our website: Bolia.com Technical information As we are constantly developing and improving our products, design and technical changes may...
Seite 3
Warnings GB: Important Notice: Please tighten each leg manually by hand without using tools. It is crucial to ensure that the leg/screw is fully tightened. After that, turn each leg an additional half turn until it reaches its maximum limit and cannot be tightened further.
Seite 4
Warnings GB: Please tighten the screws/legs after 4-5 weeks of use and then subsequently every 4-5 month. DK: Spænd skruerne/benene efter 4-5 ugers brug og derefter hver 4.-5. måned DE: Ziehen Sie die Schrauben/Beine nach 4 bis 5 Wochen Gebrauch und anschließend alle 4 bis 5 Monate nach.
Seite 5
Use of the product GB: This product is only for indoor use. DK: Dette produkt er kun til indendørs brug. DE: Dieses Produkt darf nur in Innenräumen verwendet werden. NO: Dette produktet er kun ment for innendørs bruk. SE: Den här produkten är endast avsedd för inomhusbruk. NL: Dit product is uitsluitend bedoeld voor gebruik binnenshuis.
Seite 6
Use of the product GB: Do not place the furniture in direct sunlight. DK: Placer ikke møblet i direkte sollys. DE: Setzen Sie die Möbel nicht direktem Sonnenlicht aus. NO: Ikke plasser møbelet i direkte sollys. SE: Placera inte möbeln i direkt solljus. NL: Plaats het meubelstuk niet in direct zonlicht.
Seite 7
Fittings and product parts A x 1 B x 2 410 mm C x 2 390 mm D x 5 590 x 540 x 445 mm ø 30 mm...
Seite 8
Assembly steps STEP 01 Tools & Special requirements STEP 02 Tools & Special requirements Back leg Front leg...
Seite 9
Assembly steps STEP 03 Tools & Special requirements Screw in completely GB: Important Notice: Please tighten each leg manually by hand without using tools. It is crucial to ensure that the leg/screw is fully tightened. After that, turn each leg an additional half turn until it reaches its maximum limit and cannot be tightened further.
Seite 10
Assembly steps STEP 04 Tools & Special requirements GB: Use one washer for each leg. The fifth washer is added to compensate if the chair is unstable. DK: Brug en spændeskive til hvert ben. Den femte spændeskive tilføjes for at kompensere, hvis stolen er ustabil. DE: Verwenden Sie für jedes Bein eine Unterlegscheibe.