VDO Remote DL 4G Installationsanleitung Seite 45

Note: Please observe the notes from page 39 and
page 43 without fail.
1. Fix the Remote DL 4G in the installation location. Screw on
the Remote DL 4G with two screws or fix it with double-sided
adhesive tape. Regularly check for intact adhesion.
2. Connect the Remote DL 4G to the power supply and CAN in-
terface (see pages 45 and 46 and the figures on pages
5 and 6).
Connecting the Remote DL 4G to the
vehicle's electrical system
Caution: "Terminal 30" (permanent power supply) must be
tapped after the vehicle's master switch.
Caution: The Remote DL 4G supply line voltage must match the
ignition voltage.
GB
45