Accessories - Homcom C30-032V00 Bedienungsanleitung

Accessories

1PC Main frame
2PCS Frame for wheels
4PCS Wheels
2SETS M8 Screw, waher and locknut set
2SETS M10 Screw, waher and locknut set
2PCS Screw with plastic
1 PAIR Front adaptors
1 PAIR Front adaptors
Assembly instructions
Step 1: Assemble the wheels on both sides of the frame and then insert both pieces of frames
with wheels into main frame.
Step 2: Push the M8 screw through aligning the holes and add the washer on each side
Then use tools to tighten with the locknuts.
Step 3: Loose the both sides screws on the top of the frame with wheels, then chosse correct
front adaptors and insert.
Make sure both metal heads are straight up when using front adaptors
Operation / Guide to using
1. Loose the screws on the top so that the position of adaptors can be adjusted.
2. Roll the stand and make sure your motorcycle front wheel is in the middle of the frame.
3. Rise the stand with circled handle and adjust the width of adaptors.
Front adaptors
Front adaptors
Then tighten the screws to lock the position of front adaptors
4. With the adaptors securely supporting the bottom of motorcycle front fork, lower the stand
frame onto the ground in order to lift motorcycle front wheel up.
Important
Always keep this stand away from children.
Check the stand is in good condition before using it.
Motorcycle Front Stand
can hold the bottom of front fork.
pin can get into the bottom holes of front fork.
EN
.