Auto-Vox Solar 3A Bedienungsanleitung Seite 9

2. Press the suction cup against the mounting surface and push the suction cup lock lever down to lock the suction cup in
place.
3. Slide the monitor onto the bracket. The angle of the monitor can be adjusted by loosening the rotary knob. Once in
desired position, tighten the rotary knob to secure.
4. Insert the monitor car charger into a 12V DC power supply.
Note:
1. You can hide the charging cable into the
decorative seam around the edge of the
dashboard, and if necessary, bundle the
excess wire with a cable tie.
2. If the 12V DC power port on your vehicle
remains on after the engine is off, be sure
to unplug the car charger before leaving the vehicle to prevent the car battery from draining out.
O
peration
Displaying Rear View
1. Turn on the camera ( Please make sure the camera is fully charged, see "Charge the Camera")
2. Start your vehicle, if the monitor is getting power then the monitor will display the rear image. (If it doesn't display rear
image, press the button on the car charger or any buttons on the monitor to activate the camera)
①
7