Installation And Use - Outwell 651277 Bedienungsanleitung

UK
WARNINGS:
1. This pump is designed to inflate items such as air mattresses and self-inflating mats. It is not intended
for continuous use exceeding 10 minutes. Extended operation may cause the pump to overheat and
become damaged.
Do not exceed 10 minutes of continuous operation.
Take a 20 minute break before resuming inflation.
2. Carefully follow the instructions on the item you are inflating. Never exceed the recommended
pressure levels. Bursting items can cause serious injury.
3. Never leave the air pump unattended while in use.
CAUTION: To reduce the risk of electric shock, do not expose the air pump to rain and
always store it indoors. Do not use the air pump in wet conditions. Do not drop the pump
into water or other liquids. Do not operate the pump with wet hands.
4. Never allow sand, small rocks, or other debris to enter the inflation or deflation port while in use.
5. Never look into or point the inflation opening towards your eyes while the pump is operating.
6. Never place your hands or fingers into the inflation or deflation opening at any time.
7. Never attempt to disassemble or get close to the openings while the air pump is operating.
8. The sound pressure level is approximately 80 dB(A).
9. his appliance can be used by children aged 8 and above, and by people with reduced physical,
sensory, or mental capabilities, or lack of experience and knowledge, if they have been given
supervision or instruction on the safe use of the appliance and understand the hazards involved.
Children must not play with the appliance. Cleaning and user maintenance must not be carried out
by children without supervision.
10. The pump contains non-replaceable batteries.
11. Do not stare directly into the light source.
12. Do not modify the product.
13. The product should only be used with the
provided charging cable.

1. INSTALLATION AND USE

1. Fully charge the battery before first use.
2. Remove the charge port cover and connect the included
charging cable to the charging port (5) on the pump and a
suitable power source (5V DC, 0.8A).
3. A full charge from 0 to 100% takes approximately 3 hours.
4. While charging, the charge indicator light will remain solid
red until the product is fully charged.
The charge indicator
shows a red light
The charger indicator
shows a green light
4
PUMP FUNCTION
1. Select a suitable valve adapter (7) and attach it to either the inflation port (1) or the deflation port
(2), depending on whether you wish to inflate or deflate.
2. Attach the valve adapter to the valve on the inflatable device and double-click the switch (3). Pay
special attention to warnings 2) and 4).
3. When deflating, it may be necessary to pinch the valve with your fingers to open the flap inside the
valve, allowing air to escape.
Inflation mode
Choose the appropriate valve Connect to the inflatable item
adapter
Deflating mode
Choose the appropriate valve Connect to the deflatable item
adapter
Lantern function
1) The lantern is turned on by long-pressing the power switch (3).
2) Press again to adjust the brightness by cycling through the 4 light modes:
50 lm / 120 lm / 220 lm / SOS.
3) The lantern is turned off by long-pressing the power switch (3).
Double-click to start.
Double-click to start
5
UK