Scope Of Delivery; Description Of Parts; Technical Data; Use - Crivit ULTIMATE CATCH ALLROUND 360-4 Gebrauchsanleitung

Congratulations!
With your purchase you have decided on a
high-quality product. Get to know the product
before you start to use it.
Carefully read the following instruc-
tions.
Use the product only as described and only
for the given areas of application. Keep these
instructions safe. When passing the product
on to a third party, always make sure that the
documentation is included.
Scope of delivery (figure A)
1 x All-round angling set (1)
1 x Double paternoster with winder and ground
weight (2)
1 x Rod protection cap (3)
1 x Carrying bag (4)
1 x Instructions for use
Description of parts (figure B)
Reel holder
Screw lock
Reel foot
Bail arm
Reel spool
Crank fixing bolt
Crank
Brake
Non-return device
Fishing line

Technical data

Rod length: approx. 360cm
Lead weight: up to 100g
Ø Fishing line: 0.35mm
Bearing capacity: 8kg
Reel size 5000 - 4 BB
Transmission: 5.2:1
10 GB
(1A)
(1B)
(1C)
(1D)
(1E)
(1F)
(1G)
(1H)
(1I)
(1J)

Use

Before initial use
Caution: Find out about national laws and lo-
cal regulations before fishing. These instructions
describe the most important notes on the article.
Angling is a very varied sport. We therefore re-
commend reading additional specialist literature
on the subject and/or getting advice from clubs
and associations.

Assembling the fishing rod

Even if this angling set is already assembled, you
must still check the following assembly points pri-
or to first use in order to ensure safe interaction
between the rod and the reel.
1. The reel foot (1C) must be inserted in the reel
holders (1A) and the screw lock (1B) is fixed
in a clockwise direction.
2. Bring the crank (1G) to the desired position
by folding it up so that the press button clicks
audibly into place. Make sure that the oppo-
site crank fixing bolt (1F) is securely fastened.
3. Release the brake (1H) by turning it anti-
clockwise. Pull sufficient fishing line (1J) from
the reel spool (1E) and feed it under the
bail arm (1D) through all the rings on the rod.
Re-tighten the brake by turning it in a clock-
wise direction.
4. Pull the rod out, segment by segment, be-
ginning at the tip (see figure C).
5. Make sure that the rings on the individual
segments are aligned (see figure D).
Deliver the bait with an overhead
cast
Make sure that the non-return device (1I) is
engaged. Grip the rod by the handset, whereby
the reel foot must be between your middle and
ring fingers.
Your index finger holds the fishing line while the
operating lever is closed and presses it down
onto the fishing rod. Open the bail arm and
guide the rod backwards past the side of your
head: your free hand is holding the grip end of
the fishing rod, thus giving additional stability
and control.