Roborock Zeo Mini Benutzerhandbuch Seite 11

Installation
❶ Removing Transit Screws
Remove the two transit screws
before use.
❷ Adjusting Leveling Feet
1
Hold both sides of the washing machine.
If it wobbles, adjust the right rear
leveling foot.
1
Unscrew the two transit screws by turning
them left using a transit screw wrench.
(Do not remove the feet)
2
Loosen the leveling foot bolts by
turning to the left with a wrench.
Black
Sheath
2
Pull out the screws and make sure to
also remove the black sheaths on the
screws. Properly store the screws and
sheaths for use during transportation.
3
Rotate the feet, and after adjusting
them to the desired height, tighten the
foot screws to keep all four feet level.
011
3
Cover the transit screw holes with
transit screw covers.
4
Do not block the gap between the feet
and the surface on which they are placed.