Switch Operation - Durofix Rz1282 Produktinformationen

WARNING
Always remove battery pack before changing accessories or making adjustments.
Be careful:
1. Before adjusting or checking the function of the tool, be sure to turn off the
power of the tool and remove the battery pack
2. Always turn off the tool before inserting or removing the battery pack
3. When removing the battery pack, press the buttons on both sides of the battery
pack and pull the battery pack out of the tool at the same time
4. When inserting the battery pack, align the battery pack tool slot, and then push
and slide it into place. Be sure to insert it fully into place until the battery pack
locks and clicks
5. Do not use brute force when inserting the battery pack. If the battery pack is
difficult to insert, the insertion method may be improper
Battery protection system
The battery pack is equipped with a protection system, which can automatically cut off
the output power supply to prolong the service life

Switch operation

To start the tool, just press the switch. To turn off the tool, just release the switch
Lock On
1. To lock on the trigger for continuous use.
2. Pull the trigger (A).
3. Push down on the lock on switch (B).
4. Release the trigger.
5. To stop the blower, pull and release the trigger.
Operation
Hold the blower tightly with one hand and move slowly for purging operation
1English1
B
OPERATION
To reduce the risk of injury, wear safety goggles or glasses with side shields.
English -7
A
C