Work Area; Electrical Safety; Personal Safety - Durofix Rz1282 Produktinformationen

operated (cordless) blower.
WARNING
Do not operate Blowers in explosive atmospheres, such as in the presence of flammable liquids, gases
or dust. Blowers create sparks which may ignite the dust or fumes.
Do not operate Blower in an area where it could contact electrical wiring or an electrically charged
object. Contact with a "live" wire or object will make exposed metal parts of the tool "live" and shock the
operator.
Do not operate Blower near moving machinery. The cable can be tangled in moving parts, pulling in the
Blower and your hands and arms.
Do not use near any heat sources such as radiators, heat registers, stoves, or other apparatus (including
amplifiers) that produce heat.
Keep children and bystanders away while operating a Blower. Distractions can cause you to lose
control.
WARNING
increase the risk of electric shock. Dry hands before turning tool on or off and before removing or
installing the battery pack.
WARNING
Stay alert, watch what you are doing and use common sense when operating a Blower. Do not use a
Blower while you are tired or under the influence of drugs, alcohol or medication. A moment of
inattention while operating Blowers may result in serious personal injury.
Use personal safety equipment. Always wear eye protection. Safety equipment such as dust mask, non-
skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal
injuries.
Do not overreach. Keep proper footing and balance at all times. This enables better control of the
Blower in unexpected situations.
CAUTION
1 When using the Dust blower, be sure to wear goggles, protective cap and mask.
2 When using the Dust blower, do not aim the nozzle at anyone in the work area.
3 Warning: if it is used on a wet surface, it will cause electric shock. Do not let the tool get wet and
store it indoors.
4 Do not block the air inlet and, or the air outlet.
4.1 When cleaning dusty areas, be careful not to plug the air inlet or blowing port.
4.2 Do not use conical nozzles smaller than the original nozzle, such as new nozzles connected to
the nozzle end through an additional installed small diameter hose or a smaller hose.
1English1

WORK AREA

Keep work area clean and well lit. Cluttered and dark areas invite accidents.

ELECTRICAL SAFETY

Do not expose Blowers to rain or wet conditions. Water entering a Blower will

PERSONAL SAFETY

BLOWER USE AND CARE
English -3