HOMCOM C30-043V00 Bedienungsanleitung Seite 3

Operation of the front stand with front adaptors
1. Loose the screws on the top so that the position of
adaptors can be adjusted.
2. Roll the stand and make sure your motorcycle
front wheel is in the middle of the frame.
3. Rise the stand with front handle and adjust the
adaptors to make the front adaptors pins get into
the bottom holes of front fork. Then tighten the
screws.
4. With the adaptors securely supporting the bottom
of the motorcycle front fork, lower the handle
frame onto the ground in order to lift the
motorcycle front wheel up.
Operation of the rear stand with paddle adaptors
1. Loose the screws on the top so that the position of
adaptors can be adjusted.
2. Roll the stand and make sure your motorcycle rear
wheel is in the middle of the frame.
3. Adjust the position of the paddle adaptors to
match the width of your motorcycle dual swing arm
and then tighten the screw with plastic.
4. Rise the stand with handle and move the stand to
where are under the swing arm, then press down
the stand in order to rise your motorcycle rear
wheel. Make sure the paddle adaptors are snug
up against the swing arm.
Operation of the rear stand with fork adaptors
1. Loose the screws on the top so that the position of
adaptors can be adjusted.
2. Roll the stand and make sure your motorcycle rear
wheel is in the middle of the frame.
3. Adjust the position of the fork adaptors to match
the width of your motorcycle bobbins on both
sides and then tighten the screw with plastic.
4. Rise the stand with circled handle and move the
stand to where fork adaptors are right under the
bobbins, then press down the stand in order to
rise your motorcycle rear wheel. Make sure the
fork adaptors are snug up against the bobbins.
Important
Always keep this stand away from children.
Check the stand is in good condition before using it.
3