VEVOR SL588 Benutzerhandbuch Seite 8

LAMINATING(COLD LAMINATING +HOT LAMINATING)
1. Place the overmoulder on the platform and connect to the power
supply, the machine enters standby mode (cold laminating light
blinks). Click on the "power click button, the cold laminating light will
always be on red and the machine will enter cold laminating state.
2. Cold laminating:This means that the machine is not heated, but
directly laminated with a single-sided adhesive cold laminating film. lt
is usually used on smooth photo paper, coated paper, etc.
3. Then click on the "One click switching" touch button to adjust the
corresponding cold laminating,80mic and 125mic hot laminating and
sealing positions.
Note: This product is recommended to use 80-125mic laminating
film for better results However, there is no restriction on the use of
lower film thicknesses(e.g.50mic-75mic also known as 5.0-7.5 silk)
6