Squeegee Streaks; Swirl Marks; Technical Specifications - Nilfisk-Advance BA 430 Bedienungsanleitung

D - BATTERY CONDITION INDICATOR OPERATION
To operate, the Brush Switch (13) or the Vac Switch (14) must be turned on to
activate the Battery Condition Indicator (19) to determine the charge condition
of the battery pack.
Listed below is the explanation of the Battery Condition Indicator (19) light
functions:
1 Flashing Red Light: Condition of battery 95% to 99% discharged.
2 Constant Red Light: 100% discharged.*
*NOTE: When the indicator glows steady RED, the operator will have 2
minutes of run time left (for batteries in good condition). The brush motor will
automatically shut off and the vac motor will continue to run for 10 minutes to
pick up any solution left on the floor.
Additional Note: If at any time during machine operation the battery system
voltage drops below 19 volts, the brush and vac motors will immediately shut
off. The red light will also glow steady to indicate a low voltage fault condition.
Check condition of batteries and recharge them.
If an overload occurs, determine and correct the cause of the overload. The
machine has an internal electronic circuit breaker built into the control board.
To reset the electronic circuit breaker, turn the switch for the affected device
off and then back on.

TECHNICAL SPECIFICATIONS

Model
Model No.
Current
Voltage, batteries
Battery capacity
Protection grade
Sound pressure level as per ISO3744 (at operator position)
Total weight (with full sol. tank and batteries)
Net weight (with empty tanks and no batteries)
Vibrations at the Hand Controls
TROUBLESHOOTING
POOR WATER PICKUP
1 Recovery tank full, float shut-off closed
2 Blocked vacuum system (squeegee hose and float cage)
3 Disconnected or damaged vacuum hoses
4 Blades worn or damaged
5 Recovery tank cover not seated properly
6 Recovery tank cover gasket damaged

SQUEEGEE STREAKS

1 Debris under the squeegee blade
2 Worn, nicked or torn squeegee blade
3 Debris build up on the squeegee blade

SWIRL MARKS

1 Running the machine with a dry brush or pad (no cleaning solution)
2 Incorrect brush or pad for the application
3 Debris caught in brush (or pad)
A
V
Ah
dB (A)/20µPa
lbs / kg
lbs / kg
2
m/s
FORM NO. 56041373 / BA 430 - 11
BA 430
56302200
40
24V/2 x 12V
105
IP23
71
376 / 171
157 / 71
2
<2.5m/s