Dimavery GA-10 Bedienungsanleitung Seite 21

GA-30
HIGH LOW
INPUT INPUT
1. HIGH INPUT
Here, you can connect the instrument via balanced 1/4" stereo jack.
2. LOW INPUT
Here, you can connect line-signals via balanced 1/4" stereo jack.
3. GAIN-CONTROL
Used to increase or lower the amount of preamp distortion generated in the Overdrive channel.
4. SELECT
With the SELECT button, you can change between the amp's two channels (Clean and Overdrive).
5. TREBLE-CONTROL
Used to increase or lower the HIs of the input signal.
6. MIDDLE-CONTROL
Used to increase or lower the MIDs of the input signal.
7. BASS-CONTROL
Used to increase or lower the LOWs of the input signal.
8. LENGTH
Used to set the reverb length.
9. DEPTH
Used to set the reverb depth.
10. VOLUME-CONTROL
With the VOLUME control, you can adjust the output signal.
11. LINE OUT
The Line Out allows connection of further devices for signal processing.
12. PHONE
Use this socket to connect the headphones. The headphone plug turns the built-in speaker off.
13. POWER SWITCH
Press this button to start operation.
GA-40
INPUT1
INPUT2
1. INPUT
Here, you can connect the instrument via balanced 1/4" stereo jack.
2. INPUT
Here, you can connect the instrument via balanced 1/4" stereo jack.
3. GAIN-CONTROL
Used to increase or lower the amount of preamp distortion generated in the Overdrive channel.
4. SELECT
With the SELECT button, you can change between the amp's two channels (Clean and Overdrive).
5. TREBLE-CONTROL
Used to increase or lower the HIs of the input signal.
6. MIDDLE-CONTROL
Used to increase or lower the MIDs of the input signal.
7. BASS-CONTROL
Used to increase or lower the LOWs of the input signal.
GA-30
SELECT
GAIN
TREBLE MIDDLE
SELECT
GAIN BASS
TREBLE MIDDLE
BASS
LENGTH
DEPTH VOLUME
LENGTH
DEPTH VOLUME LINEOUT
11
21/24
PHONE
LINEOUT POWER
12
11 13
GA-40
GUITAR AMPLIFIER
PHONE
POWER
12
13
00046217.DOC, Version 1.2