Powerboost Mode - Rommelsbacher Cts 2000/In Bedienungsanleitung

PowerBoost mode

a.) Aktivate the PowerBoost mode
• Tap the Boost touch key.
• The appliance switches to PowerBoost mode.
• The performance of the appliance is increased briefly and for a specified
• After the time has run off, the appliance switches back to the previously
b.) Premature termination of the PowerBoost mode
• Tap the Boost touch key again.
• Tapping the touch key is confirmed with a signal tone and -b- in the
• The PowerBoost mode is no longer active and the appliance switches
36
 Tapping the touch key is confirmed with a signal tone and the right
display field shows -b-.
time to the maximum power.
In power level mode the booster time is active as follows:
Level 1 + 2: 20 seconds
Level 3 + 4: 40 seconds
Level 5 + 6: 60 seconds
In temperature level mode the booster time is active as follows:
all temperatures: 60 seconds
selected operating mode.
 The -b- on the right of the display goes out.
NOTE: While the PowerBoost mode is active, the possibly set runtime
setting (timer) pauses.
PLEASE NOTE: In the PowerBoost mode, the maximum permitted tempe-
rature is 200 °C. If the temperature sensor measures a higher value, there is
no power output until the temperature has dropped down to a tolerable
value again!
Example 1: Is the temperature setting 220 °C and the measured tempe-
rature lower than 200 °C, then the appliance continues to heat with the
PowerBoostmode until 200 °C is measured.
Example 2: Is the temperature setting 220 °C and the measured tempe-
rature higher than 200 °C, then the appliance does not heat with the
PowerBoost mode until the measured temperature has dropped below
200 °C. In high temperatures, please use the PowerBoost mode with
caution!
right display field disappears.
back to the previously selected operating mode.
Level 7 + 8: 180 seconds
Level 9 + 10: 300 seconds