Levelling; Location - AEG Electrolux S25KA78 Benutzerinformation

1. Fit the spacers into the holes. Make sure
that the arrow (A) is positioned as
shown in the picture.
2. Turn counter-clockwise the spacers
through 45° until they lock into place.

Levelling

When placing the appliance ensure that it
stands level. This can be achieved by two adjust-
able feet at the bottom in front (2). If necessary
adjust the feet by removing the spacer (1).

Location

The appliance should be installed well away
from sources of heat such as radiators, boilers, di-
rect sunlight etc. Ensure that air can circulate
freely around the back of the cabinet.To ensure
best performance, if the appliance is positioned
below an overhanging wall unit, the minimum
distance between the top of the cabinet and the
wall unit must be at least 100 mm . Ideally, how-
ever, the appliance should not be positioned be-
low overhanging wall units. Accurate levelling is
ensured by one or more adjustable feet at the
base of the cabinet. If the cabinet is placed in a
corner and the side with the hinges facing the wall, the distance between the wall and
the cabinet must be at least 10 mm to allow the door to open enough so that the
shelves can be removed.
WARNING!
It must be possible to disconnect the appliance from the mains power supply; the plug
must therefore be easily accessible after installation.
Installation
A
45˚
31
1
2