Fm Wireless; Mm Line-Out Connection; Operation; Navigating Menus - Renkforce Rf-Crdab-100 Bedienungsanleitung

9.1 FM wireless

Preconditions:
a
3.5 mm line-in cable is disconnected.
a
You have identified an available FM channel on your car radio.
1. Press the button to access enter FM transmission frequency setting.
2. Rotate the multifunction button "M" to adjust the frequency.
3. Press the multifunction button "M" make the selection.
4. Access your car radio and tune into the selected radio station.
Notes:
– In some cases, the FM transmitter may interfere with DAB station scanning if the FM frequency is close to the
DAB station frequency.
– To prevent interference, the FM transmitter will stop working temporarily while scanning for DAB stations.
– (If applicable) once the DAB station scan is complete, the FM transmitter will automatically adjust to a fre-
quency that does not interfere with the DAB signal.

9.2 3.5 mm line-out connection

Connect the product directly to your car audio system via 3.5 mm audio cable.
■
Connect one end of the 3.5 mm audio cable to the "AUXOUT" jack on the product, and the other end to 3.5 mm
input on your car audio system.

10 Operation

10.1 Navigating menus

1. Press and hold the menu button "MENU" to enter settings.
2. Rotate the multifunction button "M" to choose a setting.
3. Press the multifunction button "M" make a selection.
à
Press the menu button "MENU" to exit settings.

10.2 Menu options

Setting
DAB Autoscan
Colour setting
Language
Delete all presets
Service following
TA MSG
Bluetooth setting
Description
Scan all available stations
Select a screen colour
Select a language
Clear all stations presets.
Switch this ON to automatically change frequency when driving into an-
other city.
Switch this ON to receive local traffic announcements while listening to
any station. This feature is not supported in all countries.
Switch the Bluetooth transmitter ON/OFF.
19