Sleep Mode; Gesture Control - Obsbot Meet Se Benutzerhandbuch

To prevent malfunctioning due to insufficient power, connect the product directly
•
to your computer or use an expansion dock with its own power supply.

Sleep Mode

Manual Sleep
•
You can manually put the device into sleep mode through the OBSBOT Center
software. If the indicator light is off, the device is in sleep mode.
Device Auto Sleep
•
Using OBSBOT Center software, you can set a specific time for the device to
automatically enter sleep mode.

Gesture Control

⚠ Please be careful not to cover your face with your hands and keep your fingers open
for the gesture control.
⚠ Please go to the link below to find the tutorial video for gesture control.
https://www.obsbot.com/explore/obsbot-meet-se
Turn On/Off Auto Framing
Enable Auto Framing: Perform the gesture operation as shown in
the figure. When the status light flashes twice and then stays a
constant purple, Auto Framing has been successfully enabled.
Exit Auto Framing: Perform the gesture operation as shown in the
figure. When the purple status light flashes twice and then turns
solid green, Auto Framing has been successfully disabled.
Zoom to 2x (Default) / Cancel
Perform the gesture control as shown in the figure. The status light
will flash twice continuously, indicating that the zoom-in or zoom-
out operation has been executed.
6