PRIXTON ROMA Bedienungsanleitung Seite 8

Battery charging:
• Please use an adapter that supports 5V/3A
(15W) or above. If you use an adapter that
supports 5W or less than 10W, the machine
cannot be charged.
• Open the decorative cover on the back and
use the Type-C charging cable (10) to charge
the battery. After connecting the cable, the
light will gradually light up according to the
charging status. When the battery is fully
charged, the LED light will go out.
Indicator lights:
• The indicator light indicates the water
temperature and power at the same time.
The progress of water boiling and charging is
displayed as shown below.
Storage method:
• Do not expose the device to fire, direct sunlight or high temperature.
• Do not leave it in the car under direct sunlight.
• Store in a cool, dry place.
Product features:
• Portable, lightweight, easy to operate.
• Supports coffee powder, tea powder, NES specification capsules.
• 15Bar extraction pressure
• Easy to clean, all accessories can be rinsed with water.
Using coffee powder:
First, open the powder bin cover (7), pour the pre-filled coffee powder into the powder
bin (7) using a coffee powder spoon (11), then compact the coffee powder using a
powder tamper (11), and finally place the powder bin into the rotating cup (8).
Extraction using capsules:
1. First check whether the power is enough, press the key switch once, display the power.
During charging, the LED light flashes, and the LED is fully lit after full charging.
2. Remove accessories. Rotate it open as shown in the picture and take out the capsule
compartment (6).
3. Installing Capsules. Place the coffee capsule into the capsule compartment (6), press
the capsule gently, and place the capsule into the rotating cup.
4. Start extraction. Tighten the rotating cup. Tighten the rotating cup (8) and the main
unit (3) (Note: If the rotating cup is not tightened correctly, extraction failure or leakage
may occur.
8