HOMCOM 853-016 Bedienungsanleitung Seite 6

EN
Cleaning and storage
Usual cleaning and storage
1. Turn off the power switch and unplug the power line.
2. Wait until the machine is completely cooled (at least 30 minutes).
3. Take out the water tank, unscrew the knob of the water tank, pour out the water in the
water tank, then clean it with water and pour the water completely. Put the water tank
back into the water storage tank.
4. Unscrew the drainage (boiler cleaning) knob at the bottom of the host by turning over,
keep the water in the host flat and then tighten the drainage (boiler cleaning) knob.
5. Place the unit in a dry place.
Boiler wall cleaning
1. Put about 50ML of white vinegar from the outlet of the machine first.
2. Add appropriate amount of water, put the kettle on the machine, plug in the power
supply, and work for about 30 minutes.
3. After working for about 30 minutes, turn off the power supply, remove the plug, and
pour out the dirt in the heater from the air outlet.
4. Then pour appropriate amount of clean water from the top air outlet, lift the machine,
shake it from left to right a few times, and then pour the water out from the air outlet.
Repeat several times in turn.
Warning: to clean the dirt on the inner wall of the boiler, you have to use the
professional cleaning agent (cleaning agent containing glycolic acid, vinegar and
baking soda) for the air conditioner and the inner wall pipe of the heater.
Do not use the cleaning agent containing acid and hydrochloric acid.
Note: be careful to prevent the danger of steam splashing when using appliances.
When filling the liquid and cleaning, unplug the power plug If the power line is damaged,
it should be replaced by a professional to avoid danger
Safety instruction
• Use the correct supply voltage and frequency, namely, AC220V-240V~50/60Hz.
• Do not share the same power supply with other high-power appliances.
• Do not immerse the unit, power line and plug in water.
• Do not allow children and handicapped persons to approach when using the unit.
• When using the machine, you must first fill cold water, and avoid adding hot water.
Otherwise, the water tank may be deformed. Pay attention to the water level often
when using it.
• Do not place the steam hose on the floor or bend it.
• Do not remove the hot parts or steam jet during use to avoid burns.
• Before storing the unit, allow the unit to cool for at least 30 minutes and drain the water
in the tank completely.
5