HOMCOM 853-016 Bedienungsanleitung Seite 5

EN
• 5) If the ironing or
brushing of the ash
layer is filled with a
brush head (optional),
the brush head is
mounted on the steam
hose nozzle as shown
in the diagram, and
then the steam hose nozzle is placed on
the hook.
If you press other fabrics, please do not
install the brush (Figure 6)
• 7) The water tank is placed on the main
engine as shown in Figure 9.
4. Ironing methods
a) Grab the lower part of the garment by hand and pull it down. Pay attention to make the
surface of garment as flat as possible.
b) Press down gently with the steam jet, then drag the jet up and down and set it through
tension after softening the fiber with high-temperature steam line.
c) Grab both sides of the clothes and tighten it when the bottom of the clothes is ironed.
Iron up and down and be careful with the hot steam from the steam jet.
d) When ironing the collar, press it down slightly. It will take a longer time for the steam
jet to be pressed on the lapel of the collar to iron up and down.
e) When ironing on the sleeves of the clothes, the sleeves shall be straightened slightly.
When the steam jet presses the lapel of the sleeves, it also takes a longer time to iron
back and forth.
f) Iron the back after ironing the front.
g) Turn off the power after ironing.
Figure 6
Figure 9
• 6) Turn the water tank knob
counterclockwise(Fig.7) and clean the cold
water in the tank.
Turn the water tank knob clockwise as
shown in Figure 8
Figure 7
• 8) Turn the knob to individual need function,
switch light is bright. It indicates that the
machine is working properly. 43 seconds
later, the steam hose spray steam, you can
iron clothes, as in Figure 10.
Figure 10
4
Figure 8