Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTRUCTIONS IN ENGLISH | TURF MOISTURE METER PRO
CHANGING THE BATTERIES:
The LCD will show an empty battery icon as shown in the picture above when it is time to
change the batteries. Remove the battery compartment cap on the RIGHT handle by turning it
counterclockwise, see (1) of Fig. 1. Insert three (3) AA/LR6 alkaline batteries, then securely tighten
the cap. Each time the meter is powered on, the display will show the remaining battery life.
Note: Battery life will only display correctly for Alkaline Batteries.
CHECKING THE METER'S ACCURACY:
Each meter is factory-calibrated with a 10-point calibration process that can be confirmed in the
field as follows. Before testing, check to see if rods appear bent and straighten if needed. Next,
wipe rods clean and dry fully. Testing should be done with both the meter and the distilled
water at room temperature.
With both hands on the meter's handles, hold the meter such that the sensor rods are suspended
in the air. The meter should read 0.0% +/- 0.0% VWC in air.
Place the meter in distilled water so that the entire length of the rods are submerged. Do not sub-
merge more than about ¼" of the sensor head below the surface of the water. Assuming both the
meter and water are stabilized at room temperature, the meter should read 100.0% +/- 3.0%
VWC in distilled water.
6
SpotOn® Turf Moisture Meter Pro Item #42550
Werbung
