Cleaning And Maintenance - Expondo Rccd-1/1 2X200 Sicherheits- Und Betriebsanleitung

Before use, check whether the power supply voltage is consistent with the nameplate, and whether the
user's power switch and fuse meet the power requirements of the machine. The machine housing must be
reliably grounded.
1. First place the machine firmly, take out one of the serving plates, and pour water into the water tank.
The water must cover the electric heating tube.
2. Press the switch to the OFF position, set the thermostat to the zero position, and turn on the power
supply. Press the switch to the ON position and adjust the thermostat knob to the required working
temperature. At this time, the orange working indicator lights up, and the heating tube starts to be
energized and heated.
3. When the temperature reaches the set value, the orange heating indicator light goes out, and the
electric heating soup pool with shelf automatically enters a constant temperature state. The user can
put food in the serving plate and adjust the water temperature as needed.
4. After the machine has been working for a period of time, the water level in the water tank will drop
due to the volatilization of steam. Please add water in time to avoid dry heating and burnt.
5. When you stop using, turn the thermostat knob to the zero position, press the switch to the OFF
position, and turn off the power at the same time.
Routine check
1. Routine inspections must be carried out frequently.
2. Check the product frequently to prevent serious accidents.
3. Stop using it when you feel the circuit or machine is malfunctioning.
4. Pay attention to check the status of the machine before and after use every day.

7. Cleaning and maintenance

a) Unplug the mains plug and allow the device to cool completely before each cleaning, adjustment or
replacement of accessories, or if the device is not being used.
b) Always unplug the device before cleaning or putting it away.
c) Use only non-corrosive cleaners to clean the surface.
d) Use only mild, food-safe detergents to wash the device.
e) After cleaning the device, all parts should be dried completely before using it again.
f) Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
g) Do not spray the device with a water jet or submerge it in water.
h) Do not allow water to get inside the device through vents in the housing of the device.
i) The device must be regularly inspected to check its technical efficiency and spot any damage.
j) Use a soft, damp cloth for cleaning.
k) Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or a metal spatula) because they
may damage the surface material of the appliance.
l) Do not clean the device with an acidic substance, agents of medical purposes, thinners, fuel, oils or
other chemical substances because it may damage the device.
m) The water tank of the machine should be cleaned regularly, and the water in the water tank should be
replaced regularly (the water can be drained from the drain valve at the bottom) to avoid the breeding
of bacteria.
8. Disposing of used devices
Do not dispose of this device in municipal waste systems. Hand it over to an electric and electrical device
recycling and collection point. Check the symbol on the product, instruction manual and packaging. The
plastics used to construct the device can be recycled in accordance with their markings. By choosing to
recycle you are making a significant contribution to the protection of our environment.
Contact local authorities for information on your local recycling facility.
EN