Werbung
EN
Operating Instructions
Product description
The Nuki Smart Lock Go motorizes existing door locks
and creates a digital access system when combined
with a smartphone.
The electronic door lock is placed on the inside of the
door on the existing cylinder with the key inserted.
The key is turned by the Nuki Smart Lock motor, but
can also be turned manually using the knob.
The integrated Wi-Fi module can establish a connection
between the Smart Lock and other Nuki actuators via
the internet. This means Nuki locking systems can be
accessed online and/or a connection to other Smart
Home products can be established.
Proper use
We recommend only mounting the Nuki Smart Lock Go
onto lock cylinders with an emergency function. If the
key is inserted from the inside, these can also be locked
and unlocked from the outside using another key.
Operating ambient temperature: +10 to -40°C,
Storage and transportation ambient temperature:
-10 to +50°C, altitude not higher than 2000m (air
pressure not less than 80kPa).
The device is only suitable for use in dry interior spaces
and must not be installed on fire doors, escape doors
or other doors with special requirements for door lock
drives.
The Wi-Fi connection may fail due to technical
malfunctions, meaning control functions may be
temporarily unavailable while you're on the move.
Any other use is deemed improper and shall result in an
exclusion of warranty and liability.
Assembly and Installation
Information on assembly can be found in the enclosed
installation instructions. To use the adhesive pad (B),
the surface must be cleaned (with residue-free cleaning
agents) and free of any grease. If your surface is made
of materials other than metal or similarly smooth
surfaces, please contact our customer service.
nuki.io/installation-guide
nuki.io/adhesive-pad-installation
nuki.io/cylinder-installation
6
Safety Instructions
The following safety and hazard instructions
not only serve to protect the device, they
also prevent personal injury. Please read
through the instructions carefully:
• The Nuki Smart Lock may fail due to technical
malfunctions and thus be unable to open the door.
Always carry the key to the lock with you or leave
it in an accessible place so that the door can be
opened manually in the event of an error.
• Improper use of the device might result in damage.
• Do not expose the device to extreme heat or cold,
direct sunlight, open flames or other extreme
conditions.
• Do not short-circuit batteries!
• Liquid can leak from defective battery cells.
If battery fluid comes into contact with skin or
clothing, rinse the affected area with water. If liquid
gets into your eyes, immediately rinse the affected
area with water and seek medical attention.
Do not rub your eyes.
WARNING!
• Replacing a battery with an incorrect type may
render a safeguard ineffective.
• Disposal of a battery into fire or a hot oven, or
mechanically crushing or cutting of a battery, may
result in an explosion.
• Leaving a battery in an extremely high-temperature
environment, such as sunshine, fire, or hot surface
may result in an explosion or the leakage of
flammable liquid or gas.
• A battery subjected to extremely low air pressure
may result in an explosion or the leakage of
flammable liquid or gas.
CAUTION! Risk of fire or explosion if the
battery is replaced by an incorrect type!
Protect batteries from moisture!
Do not expose batteries to fire!
This product and its packaging materials
contain small parts which children might
swallow; therefore, store it away from
children under 36 months of age.
This product is not a toy. Leaking or damaged batteries
might cause chemical burns.
Werbung
