Operation Of The Device; Focus Adjustment; Image Settings - Overmax Multipic 4.5 Bedienungsanleitung

A.
Connect the USB-C cable to the projector's battery and power supply (fig. 1).
Recommended specifications for a power supply that plugs into the USB-C port to
charge the battery: 20V DC 1A.
B.
Connect the battery to the projector (fig. 2), then connect the power supply to the
power socket (12, fig. A) and to the power source. It takes approximately 2 hours to
charge the entire device.

OPERATION OF THE DEVICE

Disconnect the battery and the projector (fig. 3) by moving the battery release slide (16,
fig. A). The battery can be used to charge other devices when connected to the USB-A
port (15, fig. A).
ON AND OFF
To switch the projector on or off, press the on/off switch (1, fig. A) or press the on/off
button on the remote control (1, fig. B). The projector ready for use will be signalled by an
on/off switch glowing red.

FOCUS ADJUSTMENT

The device has an electric Focus function set by remote control. Make sure the device
is standing still and the projection surface is completely flat. Otherwise, it will not be
possible to adjust the focus of the image.
To improve the sharpness of the projected image, use the focus adjustment buttons on
the remote control (4, 10, fig. B).

IMAGE SETTINGS

Go to "Settings" > "Image settings" (fig. 4) to set:
•
Projection method,
•
Zoom,
•
Colour range,
•
Image aspect ratio,
•
Image mode,
•
Brightness.
EN