Network Setup; Network Type - Samsung PS50B650 Bedienungsanleitung

If you apply a security system other than the systems listed below, it will not work with the TV.
N
- When applying the security key for the AP (wireless IP sharer), only the following is supported.
1) Authentication Mode : OPEN, SHARED, WPAPSK, WPA2PSK
2) Encryption Type : WEP, TKIP, AES
- When applying the security key for the Ad-hoc mode, only the following is supported.
1) Authentication Mode : SHARED, WPANONE
2) Encryption Type : WEP, TKIP, AES
If your AP supports WPS(Wi-Fi Protected Setup), you can connect to the network via PBC (Push Button Configuration) or PIN
N
(Personal Indentification Number). WPS will automatically configure the SSID and WPA key in either mode.
If the device isn't certified, it may not connect to the TV via the 'Samsung Wireless LAN Adapter'.
N

Network Setup

Network Type

❑
Select Cable or Wireless as the method to connect to the network.
The menu is activated only if the 'Samsung Wireless LAN Adapter' is connected.
N
• Cable : Connect to network using a cable.
• Wireless : Connect to network wirelessly.
Network Setup
❑
Cable Network Setup (when Network Type is set to Cable)
„
Please check if the LAN cable is connected.
N
Internet Protocol Setup → Auto / Manual
•
• N etwork Test: You can test or confirm the network connection status after setting up the network.
When unable to connect to a wired network
N
If your Internet service provider has registered the MAC address of the device used to connect to the Internet for the first time
and authenticates the MAC address each time you connect to the Internet, your TV may not be able to connect to the Internet
as the MAC address differs from that of the device (PC).
In this case, ask your Internet service provider about the procedures to connect devices other than your PC (such as your TV)
to the Internet. If your Internet service provider requires an ID or password to connect to the Internet (network), your TV may not
be able to connect to the Internet. In this case, you have to enter your ID or password when connecting to the Internet using an
Internet Sharer (Router).
The internet connection may failure to a firewall problem. In this case, contact your Internet service provider. If you cannot
connect to the Internet even if you have followed the procedures of your Internet service provider, please contact a Samsung
Electronics.
Cable Network Setup-Auto
„
If you connect the LAN cable and it supports DHCP, the Internet Protocol (IP) Settings are automatically configured.
1. Set Network Type to Cable.
2. Select Cable Network Setup.
3. Set Internet Protocol Setup to Auto.
The Internet Protocol is set automatically.
N
4. Select Network Test to check the network connectivity.
Cable Network Setup-Manual
„
To connect the TV to the LAN using a static IP address, you must set up the Internet Protocol (IP).
Please check if the LAN cable is connected. (See page 28)
N
1. Set Network Type to Cable.
2. Select Cable Network Setup.
3. Set Internet Protocol Setup to Manual.
4. Set up IP Address, Subnet Mask, Gateway and DNS Server.
Press the number buttons on the remote control when you set the Network manually.
N
5. Select Network Test to check the network connectivity.
English - 30
Broadcast
Security
Network
►
General
Continued...