AbleNet iTalk4 Gebrauchsanleitung Seite 6

Always be sure to wear the appropriate personal protective equipment such as protective gloves and
safety glasses.
Cleaning Your Device
Before disinfecting your device, remove any dirt or debris that may be on the device.
1. Turn the device off and remove the batteries.
2. Remove any large chunks, visible heavy dirt, or debris that is attached to the device.
3. Wipe down the device with cleaning wipes.
4. Use a cotton swab soaked with cleaner to get into any tight areas that were not accessible with
the cleaning wipes.
5. Let the device completely dry.
Disinfect Your Device
Now that the device is clean, it is time to disinfect it. Changing protective gloves may be required
before disinfecting the device to ensure no dirt or debris is transferred back to the device.
1. Make sure the device is still turned off and that the batteries are removed.
2. Use a clean towel or wipes with Virucidal, Bactericidal, Pseudomonacidal, Tuberculocidal, or
Fungicidal to disinfect the surfaces of the device. It is important to note that these chemicals
only disinfect when they are wet and should be left wet on the device for at least 4-minutes.
3. Use a cotton swab soaked with Virucidal, Bactericidal, Pseudomonacidal, Tuberculocidal, or
Fungicidal to disinfect the tight areas that were not accessible with the towel or wipes. Make
sure the chemical stays wet on the device for at least 4-minutes.
4. Let the device air-dry entirely before using it.
TROUBLESHOOTING
Does not play message(s)
If the iTalk4 does not play a message, check the following:
1. Verify you have fresh alkaline batteries. We do not recommend any other battery chemistry.
2. Verify that batteries are installed correctly. You can place the AA batteries in the wrong
orientation.
3. Verify that iTalk4 is turned on and the volume level is turned up.
iTalk4 has low volume
When activated, iTalk4 is too quiet.
1. Make sure iTalk4 is turned up all the way.
2. Rerecord message. The louder the sound being recorded, the louder the sound will playback.
PREVENTATIVE AND REGULAR MAINTENANCE
Clean the iTalk4 if necessary. No scheduled maintenance is required.
REUSABLE
If the device is intended to be reused, it must be cleaned and disinfected between uses in accordance
with standard infection control procedures. Reuse is appropriate only if the device remains in good
working condition and shows no signs of material degradation.
Instructions for Use – iTalk4
Page 6 of 7