Marechal Electric RETTBOX S Bedienungsanleitung Seite 13

►WIRING AND INSTALLATION
BOX
• Use the housing seal as a template for
cutting and drilling the bodywork;
• Rivet the inserts using RIVKLE® BRK 01
Böllhof pliers
• Wire the box respecting the marking
of the terminals.
• If any, connect the compressed air
hose;
• Wire the LED indicating the presence
of supply voltage on the terminals of
contacts 1/- and N/+;
• If necessary, stick the supplied
identification adhesive labels near the
indicator lights:
identification of the voltage presence
indicator;
identification of the battery charge
indicator.
• Wire the ejection device to the
terminals of the vehicle starter, in 1.5
mm² minimum;
• Pass the conductors under the elastic
tape and assemble the rear cover of the
housing. Assemble the housing and its
seal on the body.
IS 43 [RETTBOX®S] Rev D.0 - 2022-02 13/50
,