Installation Guide
- Hardware Installation
1. Detach the upper cover.
2. Plug in the power cable and place the product onto a stable surface.
3. Use the measuring cup to add water and then add 2~3 drops of
essencial oil for each 100ml water. Do NOT add when the power is on.
Do NOT excess the MAX mark in the water tank.
4. Attach the cover and plug the power adapter in a socket. You will hear
the product "Beep" once.
5. Short press the LIGHT button to turn on the ambient LED light. The color
will start to cycle automatically. If you prefer a certain color, you can
short press the LIGHT button again to keep the current color. Short press
the LIGHT button again and then the color will start to cycle
automatically again. Long press the LIGHT button will turn off the
ambient LED light.
6. Short press the MIST button to turn on the sprayer. Each time you short
press the button, the product will cycle among light spray mode, heavy
spray mode, and off. Long press the button will reset the product.
Attention:
1. If the product is knocked over by accident or water leaked accidentally,
please unplug the power adapter immediately and then dry the
product.
2. The amount and density of the spray vary slightly on different devices. It
depends on water you use, temperature and humidity of the environ-
ment, and air flow in your room. It's not a product defect.
3. The product will power off automatically when water runs out.
4. Please use natural essential oil only. Any chemical ingredients might
damage the product.
Fig1
Fig4
ON/WIFI
LIGHT
MIST
Fig2
Fig5
3
ON/WIFI
LIGHT
MIST
Fig3
Fig6