MSW Motor Technics MSW-PBR-1016 Bedienungsanleitung Seite 72

Basic Bending
Bending operations require the fingers to be parallel with the edge of the clamping
block and require the setback and clamping pressure to be correctly adjusted for the
thickness of the workpiece
To perform a basic bending operation
1. Mark the desired bend on the workpiece.
2. Open the clamping leaf and insert the workpiece between the fingers and the
clamping block.
3. Align the fingers to the bend mark on the workpiece and clamp it in place.
4. Lift the bending leaf until the workpiece has reached the desired bend angle.
5. Raise the clamping leaf and remove the bent workpiece
Spacing Fingers
The fingers can be spaced apart for clearance when making pans or boxes. This
requires removing one or more of the fingers so that you can space the others to
match the width of your pan or box as shown below
EN