Zibro Aida Installationshandbuch Seite 62

4
62
install_Aida_'10.indd 62
Zibro authorized installer.
First: disconnect the chimney from the stove.
To clean the back outlet flue gas outlet (See picture 18)
1. Remove the maintenance cover from the back of the stove (see chapter D.3.4)
2. Remove the cap (only when top outlet is used) (see picture 19)
3. Clean the internal stove pipe with a cylindrical brass brush and a vacuum cleaner.
See picture 20.
4. Replace the closing cap.(see picture 19) (only when a top outlet is used)
To clean the top outlet flue gas outlet (See picture 21)
1. Remove the cap (only when back side outlet is used)
2. Clean the internal stove pipe with a cylindrical brass brush and a vacuum cleaner.
See picture 21.
3. Replace the closing cap (only when a back side outlet is used)
After maintenance make sure to carefully connect the chimney to the flue outlet
of the stove again. This connection must be airtight and heat-proof.
Picture 18
Picture 21
e spare parts
Only use original by Zibro agreed spare parts.
To have your spare parts order been taken care of in the most efficient way, always
issue the following information upon ordering parts:
• serial number of the stove for which the specific part is mentioned
• number of the part in the exploded view
• part name (also mentioned in English language in exploded view)
• quantity
Picture 19 Picture 20
11-5-10 13:43