Inhaltszusammenfassung für SolarEdge ONE EV Charger
Seite 1
SolarEdge ONE EV Charger Quick Installation Guide Version 1.0 MAN-01-01246-1.0 Online version (Sticker) Serial no. + PIN no.
Seite 2
WARNING/WARNUNG/ATTENTION/ATTENZIONE EN: Installation, commissioning, maintenance or retrofitting of the charging station must be performed by correctly trained, qualified, and authorized electricians who are fully responsible for compliance with existing standards and installation regulations. Montage, erste Inbetriebnahme, Wartung oder Nachrüstung der Ladestation müssen von einschlägig ausgebildeten, qualifizierten und befugten Elektrofachkräften durchgeführt werden, die dabei für die Beachtung der bestehenden Normen und Installationsvorschriften voll verantwortlich sind.
Seite 3
4×20 mm 5×50 mm 8×40 mm Sealing plug Scr ews Scr ews Anchors ×1 ×4 ×4 ×4 4×8 mm Screws ×2 Cable clamp Cable clamp Cable clamp RFID ×1 ×1 ×2 MAN-01-01246-1.0...
Seite 7
Power ON LEDs Orange clignotant - Arancione pulsante - Oranje knipperend עמדה כתום מהבהב Pulsing orange - Not Pulsierendes Orange - Nicht Non configuré Non configurato - Niet לא מוגדרת configured konfiguriert geconfigureerd Orange constant - Arancione costante - Oranje constant - מושבת...
Seite 8
NOTES For SolarEdge Home, complete the setup using the SolarEdge EV SetApp • application. For SolarEdge ONE EV for C&I, Wevo, and third-party CPMS’s, ensure that the • EV charger is set up in the CPMS system BEFORE commissioning. MAN-01-01246-1.0...
Seite 9
Installation Datasheet Online QIG video SolarEdge Commissioning Manual/Anleitung Manuel/Manuale support video MAN-01-01246-1.0...