Safety Measures - Thermex Runa-Serie Gebrauchsanweisung

"pressure" of water at the input of the IEWH). The temperature of tap water can vary
significantly throughout the year: from 5 °C in winter to 20 ° C in summer. Therefore, at
the same water temperature at the outlet of the HDPE, the water flow in winter can be
significantly less than in summer.
To protect against overheating, a thermal switch is provided in the IEWH, which
disconnects it from the mains in the event of such a situation. The thermal switch does
not serve to protect the IEWH from failure due to high water pressure resulting from
improper connection and operation of the IEWH.
The IEWH is equipped with a ceramic cartridge with an extended service life.
The device has an information display that displays the temperature of the
the outlet of the water heater.
You should pay the attention of children that they must not play with the
IEWH. The IEWH is not to be used by persons (including children) having
limited physical capacities, tactual disorders or mental disabilities, as well
as by persons who do not know how to use an IEWH, except for the cases
when they are observed or instructed by the people responsible for the
IEWH safety.
Electric wire, safety devices, and switchgears should comply with the power capacity
of the appliance to be connected. Connect the appliance only to the electrical network
having the parameters set in the identification plate on the appliance body.
Before installing, check the electrical network and make sure that it has a ground
loop. It is prohibited to use the IEWH if there is no ground loop.
It is mandatory to install additional filters when the IEWH is used in outdated water
supply systems that have a large quantity of suspended particulate matter and impurities
in the flowing water.
IT IS PROHIBITED:

Install the IEWH except strictly vertically on the sink;

Independently make changes to the design of the device;

Install any shut-off valves, valves at the outlet of the water from
the IEWH, or attach additional faucets, shower watering cans,
dividers to the outflow of the IEWH;

Leave a working IEWH unattended;

Turn on the IEWH without installing it on the sink and filling it with
water;

Use contaminated water with sand, rust or silt (to pre-purify the
water at the input of the IEWH, it is necessary to use filters with a
degree of purification of at least 200 microns);

Turn on the IEWH with a damaged network cable;

Turn on the tank when the water freezes in it or use it at an
ambient temperature below 0 ° C;

Use the appliance in uncovered and unheated rooms;
5.

SAFETY MEASURES

water at
3