VEVOR MHTJXM01F Benutzerhandbuch Seite 12

head with a small amount of clean water, and then wipe the water stains
witha soft cloth.
3. The machine should be installed on a supported workbench, keeping a distance
from the ground.
4. Before starting the machine, please check whether the voltage of the
power supply used is consistent with the voltage of the machine used. Ensure
that the contact between the socket and the machine meets the safety
standards, the leakage protection switch and ground wire are installed, and
everything meet the electricity requirements.
1. Press the switch to turn on the machine and wait for 1-2 minutes.
Observe whether the machine runs smoothly when the spinning head of
the machine is rotating. If the vibration is too severe, the machine needs to
be adjusted. It must be ensured that the machine is placed stably.
2. Adjust the voltage knob to Max, and the voltmeter will change with the
adjustment. Warm up the machine for 2-3 minutes. After preheating, the
voltage can be adjusted according to the user's temperature requirements.
3. First, pour half a teaspoon of sugar, test the degree of heating and
sugar production. When everything is okay, then pour a spoonful of clean
white sugar in the center of the Spinner Head.
4. After about 3 seconds, the cotton candy starts to squirt out. Take a
bamboo stick and rotate it a few times along the inner wall of the bowl.
Then, place the stick horizontally and rotate it over the spinning head to
form cotton candy. Different shapes can be made by tilting the sticks.
5. After making enough cotton candy, turn off the machine.
1. The machine needs to be cleaned after the cotton candy is made,
otherwise the spinning head may be blocked. Keep the machine running
during the cleaning process, pour a small amount of water into the rotor, then
the rotor will shake off the water slowly. After that, turn off the machine and
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
11