Product Characteristics; Commissioning - Ruris Rse 1900S Bedienungsanleitung

EN
The electric sprayer has been designed to reduce effort and increase yields and work performance.
Advanced technology combined with a unique design with a smooth and compact outline makes this
product easy to carry. The sprayer is ideal for the control of diseases that affect different types of crops,
flowers and garden plants, respectively in the control of diseases in birds and in animal stables undergoing
restoration
.
Assembly:
Make sure that there are no mounting components inside the pool.
•
Mount the hose on the tank body.
•
Attach the lance to the control handle.
•
Connect the straps in the two locations of the sprayer, then adjust them to the desired height.
•
Attach the lance support to the body of the basin, then connect the straps to the two sprayer
housings, then adjust them to the desired height.
Make sure that all assembly components are properly tightened, ensuring their tightness, otherwise there
may be substance losses.
Note: The graduations on the tank are informative, for a precision dosage use a standard graduated
vessel .
Product features: It has a linear and modern profile. The line was designed respecting the natural
undulation of the human back, with the aim of ensuring better contact and maximum carrying convenience.
It has a compact and elegant design, easy to carry, assemble and disassemble.
Maintenance:
Before the verification operation, make sure that:
- Unplug the power cord
- Turn off the sprayer
- The tank is empty
Constantly inspect and carefully maintain the sprayer's component parts for proper operation and to avoid
possible problems.
•
Check that the connections and parts are well fixed.
•
Remove any impurities in the pump filter.
•
Replace damaged parts only with original RURIS spare parts.
If you notice low efficiency or a problem with the sprayer, it is recommended to request an inspection at an
authorized RURIS service.
Using the charger
Make sure that the input parameters correspond to the mains supply parameters. Otherwise,
contact the manufacturer. The pool pump battery is supplied by the manufacturer already
charged. However, there is the possibility of discharging it during transport, for this reason the
battery must be charged before use.
Introduction of chemicals
Before use, remove the tank cap and fill the tank with the chemicals to be used, replace the
cap, turn the switch to the ON position and press the handle lever to start use. Never put the
pump in water to clean or fill it.
Vaporization
Turn on the power switch, point the spray lance in the desired direction and press the lever
on the lance handle to start spraying
3

4. PRODUCT CHARACTERISTICS

5. COMMISSIONING

.