Sprayer Problems, Causes And Solutions; Cleaning And Storage - Ruris Rse 1900S Bedienungsanleitung

EN
The operator must advance at a constant speed to avoid excessive or insufficient vaporization at some
points; must vaporize according to the direction of the wind, generally in a vertical direction or at an angle
of not less than 45° to the wind. The operator's position must be overhead and spray the vapor downwards.
Pressure regulation
Putting the sprayer into operation is done only after liquid has been added to the tank, at least 1/2 of its
volume.
To adjust the pressure, turn the adjustment lever. The spray size can be varied and
the spray power can be increased depending on the nozzles used and the items to
be sprayed. Turn the adjustment lever clockwise to increase the pressure and
decrease the spray amplitude. Turn the lever counterclockwise to reduce pressure
and increase spray amplitude.
To stop the pump, turn the power switch to the off position and make sure the
pressure control knob is turned fully counterclockwise.
Note: The images are informative, the supplier reserves the right to make
structural and functional changes to the machine presented in this manual.

6. SPRAYER PROBLEMS, CAUSES AND SOLUTIONS

Problems
The motor does not run,
although the pump is
turned on
Strange noises are heard
while the engine is
running
There is a loss in the lower
area of the base
Poor quality vaping
Before being transported and at the end of each use, the sprayer must be cleaned to avoid the formation
of corrosion and blocking of the sprayer due to pesticide liquids. Also, cleaning the product regularly can
avoid causing damage to crops where a used product can mix with previously used leftover product.
How to perform the cleaning operations: Clean the surface of the sump pump with a wet material. Fill the
tank with water and shake vigorously; operate the pump to remove the water used for spray cleaning.
Filters and tank spray can be disassembled to be cleaned with water.
The sprayer must be stored in a dry place, away from any heat source where children cannot access.
Do not dispose of electrical equipment, industrial electronics and components in household waste!
Information on WEEE. Considering the provisions of GEO 195/2005 - regarding environmental
protection and GEO 5/2015. Consumers will consider the following indications for handing over
electrical waste, specified below:
- Consumers have the obligation not to dispose of waste electrical and electronic equipment (WEEE) as
unsorted municipal waste and to collect this WEEE separately.
- The collection of these named wastes (WEEE) will be carried out through the Public Collection Service within each
county and through collection centers organized by economic operators authorized to collect WEEE. Information provided
by the Environmental Fund Administration
- Consumers can hand in WEEE free of charge at the previously specified collection points.
4
CAUSE
○ The pressure is too low
○ The battery is discharged
○ The start switch is faulty
○ The engine is damaged
○ The screws are loose
○Pump hoses are
damaged
○ Low pressure
○ The holes inside the sprayer are
clogged
○ There are leaks at the sprayer holes
and the diaphragms
○ There are leaks at the hose joints.
○ The battery is discharged

7. CLEANING AND STORAGE

www.afm.ro or the journal of the European Union.
Solutions
○ Increase the pressure
○ Upload it
○ Replace the switch
○ Replace the motor in an authorized
RURIS service
○ Squeeze them
disconnected or ○ Disassemble the base and replace
or connect the hoses
○ Increase the pressure
○ Remove impurities
○ Replace the membranes
○ Tighten the necklaces
○ Charge the battery