Walter ZHQ1821SH-ADC Bedienungsanleitung Seite 15

Usage
CAUTION!
The housing of the heater head and its
parts become very hot during operation.
Avoid touching the product or these parts
at all costs.
Risk of burns.
• As the product remains hot for some
time after switching off, allow it to
cool down completely before moving
or touching it.
• Do not use the product for animal
husbandry, farming or gardening.
• The product should not be operated
with a program switch, a timer or
any other device that turns on the
product automatically. There is risk of
fire caused by unsupervised use, any
covers or incorrect installation.
• Always disconnect the product from
the mains when it is not in use.
Never operate the product without the
cover on the heater head
Switch on the product only after it has
attained the ambient temperature.
Condensate water can damage the
product.
• Select the desired heat setting I, II or III to get
the desired performance. (Fig. O).
- Switched off = Heat setting I + II to "0"
- Heat setting I = about 900 W
- Heat setting II = about 1,200 W
- Heat setting I + II = about 2,100 W
Maintenance, cleaning,
storage and transport
WARNING!
Disconnect the mains cable of the
product before cleaning, storage,
maintenance or repair.
611626_Buch_DE_EN_FR_CZ_SI_HR.indb 19 611626_Buch_DE_EN_FR_CZ_SI_HR.indb 19
Maintenance
The product requires very little maintenance.
Regularly check the condition of the product.
Check whether:
- the on / off switch 2 is not damaged,
- the stand 7 and the support table 4 are
in good condition,
- the mains cable 8 and the plug are not
damaged.
If necessary, use a soft brush to clean the
product.
If you notice any damage, get it fixed in a
specialist workshop to avoid any risks.
Cleaning
Make sure that liquids do not get inside
the product.
• Clean the product with a moist cloth. Never
use strong and / or abrasive cleaning
agents or solvents. Allow all the parts to dry
completely.
.
1
• Make sure that the ventilation slots are open.
• Clean the body regularly with a soft cloth.
Storage
• Disconnect the mains plug of the product
before storage
• Clean the product before storage (see chapter
"Cleaning").
• Keep the product in a safe, cool, dry and well-
ventilated place in its original packaging, out
of the reach of children when it is not being
used.
Transport
• Disconnect the mains plug of the product
before transport.
• Always carry the product using the handle
provided for this purpose.
• Transport the halogen heater protected from
shocks and vibrations and in its original
packaging.
CAUTION!
Usage
19
20.09.2022 10:58:10 20.09.2022 10:58:10