Environment Protection; Control Panel; Temperature Setting Buttons - JUNO Electrolux JRG 90106 Benutzerinformation

4 electrolux
• The appliance must not be located close
to radiators or cookers.
• Make sure that the mains plug is accessi-
ble after the installation of the appliance.
• Connect to potable water supply only (If a
water connection is foreseen).
SERVICE
• Any electrical work required to do the
servicing of the appliance should be car-
ried out by a qualified electrician or com-
petent person.
• This product must be serviced by an au-
thorized Service Centre, and only genu-
ine spare parts must be used.

ENVIRONMENT PROTECTION

This appliance does not contain gasses
which could damage the ozone layer,

CONTROL PANEL

Fridge Pilot light
1
Fridge ON/OFF switch (Ein/Aus)
2
Fridge temperature regulator, + button
3
Fridge temperature indicator
4
Fridge temperature regulator, - button
5
Schnellkühlen indicator
6
Schnellkühlen button
7
SWITCHING ON THE FRIDGE
1. Insert the plug into the mains socket.
2. Press ON/OFF switch .
3. The Pilot Light will light up.
SWITCHING OFF THE FRIDGE
1. Keep ON/OFF switch pressed for more
than 5 seconds.
2. A countdown on the temperature indi-
cator, from -3 -2 -1 will be shown.
When "1" appears the fridge is turned
off. The temperature indicator switches
off. The Pilot light switches off.
1 2 3 4
in either its refrigerant circuit or insula-
tion materials. The appliance shall not
be discarded together with the urban
refuse and rubbish. The insulation foam
contains flammable gases: the appli-
ance shall be disposed according to
the applicable regulations to obtain
from your local authorities. Avoid dam-
aging the cooling unit, especially at the
rear near the heat exchanger. The ma-
terials used on this appliance marked
by the symbol
5 6 7

TEMPERATURE SETTING BUTTONS

The temperature is adjusted using the tem-
perature setting buttons. These buttons are
connected to the temperature indicator.
• The temperature indicator is switched
over from the indicator of the ACTUAL
temperature (Temperature indicator is il-
luminated) to the indicator of the DE-
SIRED temperature (Temperature indica-
tor flashes) by pressing one of the Tem-
perature setting buttons.
• Each time one of the two buttons is
pressed again the DESIRED temperature
is adjusted by 1°C. The DESIRED tem-
perature must be reached within 24
hours.
If neither button is pressed, the temperature
indicator automatically switches back after
a short period (approx. 5 sec.) to the indica-
tor of the ACTUAL temperature.
DESIRED temperature means:
The temperature that has been selected for
inside the fridge. The DESIRED temperature
is indicated by flashing numbers.
are recyclable.