Werbung
Verfügbare Sprachen
Verfügbare Sprachen
PRODUCT MAINTENANCE
Replacing the dust bag
Before replacing the dust bag, remove the power cord plug from the wall outlet. Always
use the vacuum cleaner with a fitted dust bag. If you forget to insert a dust bag or it is
fitted incorrectly, the cover cannot be closed completely - align the position of a dust
bag and close the cover.
• After disconnecting flexible hose, open the front cover by lifting it upwards.
• Release the dust bag lock and remove the bag from the guides, if filled with dust.
• Insert an empty or new dust bag by sliding it into the guides.
• Close the cover by pressing it down until it clicks.
Clean and replace the inlet filter
• Before cleaning the filter, remove the power cord plug from the wall outlet.
• The filter shall be cleaned when there are visible stains on it, wash the filter in warm
water with no detergent. Use it only when completely dry.
• Always use the vacuum cleaner with a filter in place.
• Failure to install the filter may result in motor damage.
1. Remove the dust bag.
2. Remove the filter by sliding it out of the guides upwards.
3. Clean the filter or replace with a new one.
4. Reinstall the filter by placing it back into the guides. Ensure the filter is completely dry
before inserting it.
If the dust bag full indicator comes on, check whether the suction brush, hose or tube is
blocked with large items stopping the air flow.
After removing the items, if present, restart the vacuum cleaner - if the dust bag full
indicator is still red, replace the dust bag with a new one.
08
Werbung
