HomeMatic IP HmIP-WKP Installations- Und Bedienungsanleitung Seite 150

Start-up
Step 3
Step 4
Step 5
Step 6
Step 7
Step 8
Step 9
Step 10
Step 11
48
Release the wiring and remove the exist-
ing switch if necessary.
Connect the conductor to the lamp/lu-
minaire at connecting terminal 2
Connect the phase conductor to con-
necting terminal L (C) .
Connect the neutral conductor to con-
necting terminal N (B) .
Connect the neutral conductor of the
lamp / luminaire to the neutral conductor
of the house installation.
Secure the dimming actuator to the
flush-mounted box using the provided
screws. Please note that the system but-
ton (A) of the actuator must be at the top
left during installation.
Fit the adapter to the rocker (see figure 4).
Now secure the rocker with the adapter
in the frame on the actuator.
Position the adapter so that both latching
lugs fit into the existing elongated holes
(see figure 5).
Switch the fuse of the power circuit back
on again.
(D).