HomeMatic IP HmIP-WKP Installations- Und Bedienungsanleitung Seite 139

Hazard information
Only dimmable 230 V LED lamps may be used.
Not dimmable 230 V LED lamps may destroy the
device and/or the light source.
The dimming actuator contains a thermal cut-off.
Please note that in the event of overheating the
loads will be switched off completely.
If the dimming actuator is operated with elec-
tronic transformers, only those which meet the
requirements of DIN EN 61347-1 (VDE 0712-30,
Part 1) along with DIN EN 61047 /VDE 0712-25,
Part 2) may be used.
The dimming actuator is only suitable for light
bulbs and high-voltage and low-voltage halogen
lamps with electronic transformers as well as
dimmable LED lamps! Please only connect ohmic
and capacitive lamp loads to the dimming actua-
tor, and no televisions, computers, motors etc.
In order to avoid changes in the level of bright-
ness, the device is able to detect ripple control
signals. However, short-time flickering of the
light source due to ripple control signals cannot
be completely excluded.
37