Anest Iwata Silver Jet IS50AU Bedienungsanleitung Seite 6

1. Screw large end of Air Hose snuggly onto air outlet (Avoid over tightening both ends of hose to avoid early wear)
2. Screw small end of Air Hose snuggly to airbrush.
a. Note: If using a brand of airbrush other than Iwata, use appropriate option from included adapter kit.
*While not guaranteed to fit all brands beyond Iwata Airbrushes, they're found to fit most.*
3. Plug compressor into a grounded wall outlet that meets all local government specifications.
a. Note: Not for use with extension cords/power strips. *Please refer to name plate on bottom of compressor for power
and voltage requirements.*
4. Turn compressor ON by pressing down on On/Off Switch on back of unit.
a. Note: Upon first use, allow to run for 5 minutes. to ensure compressed air is being released and no abnormal sounds
or vibrations are present.
5. Adjust air pressure by turning air bleed valve knob toward "+" to increase pressure and "-" to decrease pressure.
6. When not in use, place front of airbrush into airbrush holder. when using a bottle-fed airbrush, place back handle of
airbrush into airbrush holder.
1. Turn compressor off.
2. Release leftover air by engaging main lever/trigger of your airbrush (being careful of any excess paint).
3. When storing your Iwata Silver Jet, you can use the electrical cord wrap feature around the base of the unit.
GETTING STARTED
ENDING A SESSION
6