Anest Iwata Silver Jet IS50AU Bedienungsanleitung Seite 4

• Always work in well-ventilated areas away from volatile, or flammable fluids and vapors.
• Stop operation immediately should you hear abnormal sounds or vibrations such as clanking.
• Compressor can become hot during prolonged use. Avoid running continuously without a break for more than
40 minutes at a time. Use caution when handling compressor at this time.
• Motor is thermally protected and automatically shuts off when overheated. If this occurs, turn compressor off
and wait to restart until unit has cooled down.
• DO NOT place air compressor between you and your work area or directly under an area being sprayed. This could
allow for over spray to flow into air intake of compressor causing internal damage to unit.
NOTE: Suggested use of an air filter is highly recommended to minimize intake of overspray, moisture, dust...etc.
Minimizing potential interference of proper compressor operation.
During extended use, unit may get warm expell moisture. To prevent this, use the Iwata Pistol-Grip Moisture Filter (FA450)
which is sold separately.
During extra humid conditions, condensation may build up and rest in hose(s). Remove air hose(s) at end of session and
drape overnight to allow to drain/dry excess moisture.
Note: How often you need this will vary depending on humidity and amount of use.
CAUTION
NOTE ON MOISTURE
4